VSA DTC Troubleshooting: 67
DTC 67:
 Brake Pedal Position Switch Stuck ON (Hardware)
  1. Turn the ignition switch ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch OFF.
  1. Test-drive the vehicle. Drive the vehicle at 10 km/h (7 mph) or more.
  1. Check for DTCs with the HDS.
Is DTC 67 indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, system is OK at this time. Check for loose terminals between the brake pedal position switch 4P connector, the ECM connector A (44P), and the VSA modulator-control unit 46P connector. Refer to intermittent failures troubleshooting. ■
  1. Turn the ignition switch OFF.
  1. Disconnect the brake pedal position switch 4P connector.
  1. Do the brake pedal position switch test.
Is the switch OK?
YES -
Go to Step 9 .
NO -
Replace the brake pedal position switch. ■
  1. Short the SCS line with the HDS.
  1. Disconnect the ECM connector A (44P).
  1. Check for continuity between brake pedal position switch 4P connector terminal No. 2 and body ground.
Is there continuity?
YES -
Repair short to body ground in the wire between the ECM and the brake pedal position switch.■
NO -
Check the fuel and emissions systems and troubleshoot the brake pedal position switch signal circuit. ■