EPS DTC Troubleshooting: 22-01
DTC 22-01:
 Engine Speed Signal (Initial diagnosis)
NOTE: If the MIL indicator is on, troubleshoot the PGM-FI system first.
  1. Turn the ignition switch OFF.
  1. Connect the HDS to the data link connector (DLC).
  1. Start the engine.
  1. Check the NE in the DATA LIST with the HDS.
Is there 0 engine rpm at idle?
YES -
Go to Step 5 .
NO -
The system is OK at this time.■
  1. Turn the ignition switch OFF.
  1. Disconnect ECM connector A (44P) and EPS control unit connector D (28P).
  1. Check for continuity between EPS control unit connector D (28P) terminal No. 3 and body ground.
Is there continuity?
YES -
Repair short to body groud in the wire between the EPS control unit and the ECM.■
NO -
Go to Step 8 .
  1. Connect ECM connector A (44P).
  1. Turn the ignition switch ON (II).