DTC Troubleshooting: P19F6 (154-22)
DTC P19F6:
 Select Actuator Motor Position Sensor Ground Line Open
  1. Turn the ignition switch ON (II).
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch OFF.
  1. Turn the ignition switch ON (II).
  1. Check for DTCs with the HDS.
Is DTC P19F6 indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch OFF.
  1. Disconnect the select actuator motor 6P connector.
  1. Disconnect the change actuator subharness B 8P connector.
  1. Check for continuity between change actuator subharness B 8P connector terminal No. 8 and select actuator motor 6P connector terminal No. 2.
Is there continuity?
YES -
Remove the clutch actuator assembly, and check for change actuator subharness A. If the wire harness is OK, replace the transmission shift change actuator. ■
NO -
Repair an open in the wire of the change actuator subharness B.■