DTC Troubleshooting: P19EE (150-23)
DTC P19EE:
 Shift Actuator Motor Rotating Pulse/Rotating Direction Sensor Supply Signal Circuit High Voltage
  1. Turn the ignition switch ON (II).
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch OFF.
  1. Turn the ignition switch ON (II).
  1. Check for DTCs with the HDS.
Is DTC P19EE indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch OFF.
  1. Disconnect the shift actuator motor 6P connector.
  1. Turn the ignition switch ON (II).
  1. Measure voltage between the shift actuator motor 6P connector terminal No. 3 and body ground.
Is there battery voltage?
YES -
Repair a short to power in the wire between the TCM (B118) and the shift actuator motor.■
NO -
Replace the transmission shift change actuator. ■