DTC Troubleshooting: P19EA (132-1)
|
DTC P19EA:
Starter Signal Malfunction (from ECM by Signal Line)
-
Turn the ignition switch ON (II).
-
With the shift lever in N position and the brake pedal pressed, check the STARTER ENABLE SIGNAL in the DATA LIST with the HDS.
|
YES
|
-
|
Repair a short to ground in the wire between the ECM (A41) and the TCM (A46).■
|
|
NO
|
-
|
|
-
Turn the ignition switch OFF.
-
Disconnect the clutch actuator subharness 10P connector from the engine compartment wire harness.
-
Turn the ignition switch ON (II).
-
Measure voltage between clutch actuator subharness 10P connector terminal No. 1 and body ground.
|
Is there battery voltage?
|
|
YES
|
-
|
Repair a short to power in the wire between the ECM (A41) and the TCM (A46).■
|
|
NO
|
-
|
|
-
Turn the ignition switch OFF.
-
Jump the SCS line with the HDS.
-
Disconnect ECM connector A (44P).
|
|