DTC Troubleshooting: P0910 (162-4)
DTC P0910:
 Select Actuator Motor System Malfunction
  1. Turn the ignition switch ON (II).
  1. Clear the DTCs with the HDS.
  1. Do the i-SHIFT System Learning (Static Mode).
  1. Check for DTCs with the HDS.
Is DTC P0910 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch OFF.
  1. Remove the transmission shift change actuator.
  1. Reconnect the 6P connectors to the transmission shift change actuator.
  1. Turn the ignition switch ON (II).
  1. Change the shift lever from D to N position, then from N to D position, and check the select actuator rod (A) operation.
Does the select actuator rod move smoothly?
YES -
Repair the transmission internal failure.■
NO -
Go to Step 10 .
  1. Turn the ignition switch OFF.
  1. Disconnect the select actuator motor 6P connector.