VSA DTC Troubleshooting: 11, 13, 15, 17
  1. Check for continuity between the appropriate wheel sensor +B and GND terminals of the VSA modulator-control unit 46P connector (see table).
    DTC
    Appropriate Terminal
    +B
    GND
    11 (Right-front)
    FR +B:
    No. 29
    FR-GND:
    No. 28
    13 (Left-front)
    FL +B:
    No. 34
    FL-GND:
    No. 13
    15 (Right-rear)
    RR +B:
    No. 30
    RR-GND:
    No. 8
    17 (Left-rear)
    RL +B:
    No. 11
    RL-GND:
    No. 10

Is there continuity?
YES -
Repair short in the wires between the VSA modulator-control unit and the appropriate wheel sensor.■
NO -
Go to Step 15 .
  1. Substitute a known-good wheel sensor for the appropriate wheel sensor (see table).
    DTC
    Appropriate Wheel Sensor
    11
    Right-front
    13
    Left-front
    15
    Right-rear
    17
    Left-rear

  1. Reconnect all connectors.
  1. Turn the ignition switch ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch OFF, then turn it ON (II).
  1. Check for DTCs with the HDS.
Is DTC 11, 13, 15, and/or 17 indicated?
YES -
Check for loose terminals in the VSA modulator-control unit 46P connector. If necessary, substitute a known-good VSA modulator-control unit and retest.■
NO -
Replace the original wheel sensor. ■