Navigation System Symptom Troubleshooting - No picture is displayed
No picture is displayed
Diagnostic Test: Navi System Link
NOTE: Always check the connectors for poor connections or loose terminals.
  1. Check the No. 23 (10 A) fuse in the under-hood fuse/relay box and No. 35 (10 A) fuse in the under-dash fuse relay box, and reinstall the fuses if they are OK.
Are the fuses OK?
YES -
Go to Step 2 .
NO -
Replace the fuse and recheck.■
  1. Turn the ignition switch to ACC (I).
  1. Operate the radio and listen to the audio.
Can audio be heard?
YES -
Go to Step 4 .
NO -
Check the ACC circuit.■
  1. Turn the ignition switch ON (II).
  1. Measure the voltage between body ground and navigation unit connector C (8P) terminals No. 1 and No. 2 individually.
Is there battery voltage?
YES -
Go to Step 6 .
NO -
If the+B wire does not have voltage, repair open in the wire between the under-hood fuse relay box and the navigation unit. If the ACC wire does not have voltage, repair open in the wire between the under-dash fuse/relay box and the navigation unit.■
  1. Turn the ignition switch OFF.
  1. Disconnect navigation unit connector C (8P).