SIL Troubleshooting
  1. Check for continuity between ECM connector No. 2 (58P) terminal No. 40 and body ground.
Is there continuity?
YES -
Update the ECM if it does not have the latest software, or substitute a known-good ECM, then recheck. If the symptom/indication goes away with a known-good ECM, replace the original ECM. ■
NO -
Repair open in the wire between the clutch pedal position switch A and ECM connector No. 2 (58P) terminal No. 40.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the clutch pedal position switch A 2P connector.
  1. Turn the ignition switch to ON (II).
  1. Check CLUTCH PEDAL POSITION SWITCH A in the DATA LIST with the HDS.
Is OFF indicated?
YES -
Replace the clutch pedal position switch A. ■
NO -
Go to Step 29 .
  1. Turn the ignition switch to LOCK (0), and wait 2 minutes.
  1. Disconnect ECM connector No. 2 (58P).