Driveshaft Reassembly
  1. Adjust the length (A) of the driveshafts to the figure as shown, then adjust the boots to halfway between full compression and full extension. Bleed excess air from the boots by inserting a flat-tipped screwdriver between the boot and the joint.
Model
Left/Right Driveshaft
Driveshaft Type
Specified Length (A)
L13Z1 engine model
Left
1
531−536 mm (20.91−21.10 in.)
Right
1
801−806 mm (31.54−31.73 in.)
R18A2 engine model
Left
1
520−525 mm (20.47−20.67 in.)
Right
2
502−507 mm (19.76−19.96 in.)
K20Z4 engine model
Left
1
517−522 mm (20.35−20.55 in.)
Right
2
504−509 mm (19.84−20.04 in.)

  1. Install the new boot bands.
    • For the double loop type, go to Step 11 .
    • For the low profile type, go to Step 20 .

Driveshaft type 1
Driveshaft type 2