Front Subframe Side Member Replacement
Installation
  1. Loosely install the front subframe side member (A) to the front subframe center member (B) and the body.
  1. Loosely install the new bolts and new nuts, and lightly tighten them.
  1. RHD model: Install the steering gearbox to subframe center member.
  1. Insert the alignment pins (C) into the alignment holes on the right and left, then align the front subframe center member and front subframe side member with the body.
  1. Tighten the subframe mounting bolts and nuts to the specified torque values beginning with the rear side of flange bolt and flange nut (D), and the upper part of flange bolt (E).
  1. Remove the alignment pins, and tighten the middle side of flange bolt and flange nut (F) to the specified torque values.
  1. Tighten the remaining subframe mounting bolts to the specified torque value.
  1. Install the stabilizer bar.
  1. Install the lower arm.
  1. Install the engine undercover.
  1. Check the wheel alignment, and adjust it if necessary.