DTC Troubleshooting: P19F6 (154-22)
DTC P19F6:
 Select Actuator Motor Position Sensor Ground Line Open
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P19F6 indicated?
YES -
Go to Step 6 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the select actuator motor 6P connector.
  1. Disconnect the change actuator subharness B 8P connector (R18A2 engine model) or change actuator subharness B 10P connector (L13Z1 engine model).
  1. Check for continuity between change actuator subharness B 8P connector terminal No. 8 (R18A2 engine model) or change actuator subharness B 10P connector terminal No. 8 (L13Z1 engine model) and select actuator motor 6P connector terminal No. 2.
Is there continuity?
YES -
Remove the clutch actuator assembly; R18A2 engine model, L13Z1 engine model, and check for change actuator subharness A. If the wire harness is OK, replace the transmission shift change actuator; R18A2 engine model, L13Z1 engine model. ■
NO -
Repair an open in the wire of the change actuator subharness B.■