DTC Troubleshooting: P0914 (162-5)
DTC P0914:
 Shift Actuator Motor Rotating Pulse Sensor Signal Circuit Malfunction
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Change the shift lever to D, then operate the shift lever between + and − positions.
  1. Check for DTCs with the HDS.
Is DTC P0914 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the shift actuator motor 6P connector.
  1. Turn the ignition switch to ON (II).
  1. Check for DTCs with the HDS.
Is DTC P0914 indicated?
YES -
Go to Step 9 .
NO -
Replace the transmission shift change actuator; R18A2 engine model, L13Z1 engine model. (A few DTCs related with open circuit will be stored at this time.)■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect change actuator subharness B 8P connector (R18A2 engine model) or TCM connector B (40P) (L13Z1 engine model).
  1. Check for continuity between the shift actuator motor 6P connector terminal No. 5 and body ground.
Is there continuity?
YES -
Repair a short to ground in the wire of the change actuator subharness B (R18A2 engine model) or change actuator subharness A (L13Z1 engine model).■
NO -
Go to Step 12 .
  1. Turn the ignition switch to ON (II).