DTC Troubleshooting: P0910 (162-4)
DTC P0910:
 Select Actuator Motor System Malfunction
  1. Turn the ignition switch to ON (II).
  1. Clear the DTCs with the HDS.
  1. Do the i-SHIFT System Learning (Static Mode).
  1. Check for DTCs with the HDS.
Is DTC P0910 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time.■
  1. Turn the ignition switch to LOCK (0).
  1. Remove the transmission shift change actuator; R18A2 engine model, L13Z1 engine model.
  1. Reconnect the 6P connectors to the transmission shift change actuator.
  1. Turn the ignition switch to ON (II).
  1. Change the shift lever from D to N, then from N to D, and check the select actuator rod (A) operation.
Does the select actuator rod move smoothly?
YES -
Repair the transmission internal failure.■
NO -
Go to Step 10 .
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the select actuator motor 6P connector.