Clutch Replacement
  1. Install the stop collar (A) and the pressure plate compressor (B).
  1. Turn the center screw (C) clockwise by hand to apply pressure on the diaphragm spring.
    Continue turning the center screw unit it stops.
  1. Be careful not to damage the pressure plate (D). Tighten (180 degrees apart) the pressure plate mounting bolts (E) in a star pattern as shown in several steps.
    Specified Torque:
    25 N·m (2.6 kgf·m, 19 lbf·ft)

  1. Turn the center screw on the pressure plate compressor counterclockwise by hand to release the pressure. Remove the pressure plate compressor, the stop collar, the center shaft, and the ring gear holder.
  1. Make sure the diaphragm spring fingers are all the same height.
  1. Do the release bearing inspection, and replace if it necessary.
  1. Install the transmission.