Clutch Replacement
Special Tools Required

Ring gear holder
 07LAB-PV00100

Center shaft
 070AF-SMGC140

Stop collar
 070AF-SMGC150

Pressure plate compressor
 070AE-0010100

Bearing driver attachment, 28 x 30 mm
 07946-1870100

Driver handle, 15 x 135L
 07749-0010000

Slide hammer weight
 07741-0010201

Bearing remover shaft 15
 07936-KC10100

Bearing remover head 15
 07936-KC10200
You must use the pressure plate compressor, the center shaft, and the stop collar required to remove and install the clutch pressure plate or you will damage it.
SPKM Manual Transmission - Engine Side
Pressure Plate Inspection and Removal
  1. Remove the transmission.
  1. Check the evenness of the height of the diaphragm spring fingers using the center shaft, and the stop collar (A), and a feeler gauge (B). If the height difference is more than the service limit, replace the pressure plate and clutch disc as a set.
    Standard (New):
    0.8 mm (0.03 in.) max.