DTC Troubleshooting: P0563
DTC P0563:
 ECM Power Source Circuit Unexpected Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Wait 10 seconds.
  1. Turn the ignition switch to ON (II).
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0563 indicated?
YES -
Go to Step 7 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the under-hood fuse/relay box and the ECM.■
  1. Turn the ignition switch to LOCK (0).
  1. Remove the battery.
  1. Disconnect ECM connector A (49P).
  1. Connect the battery.
  1. Measure the voltage between ECM connector terminal A7 and body ground.
Is there battery voltage?
YES -
Go to Step 15 .
NO -
Go to Step 12 .
  1. Remove the battery.
  1. Disconnect under-hood fuse/relay box (white) connector D (20P).