F-CAN Circuit Troubleshooting - PGM-FI System
  1. Measure the resistance between ECM connector terminals A3 and A4.
Is there about 2.34−2.86 kΩ?
YES -
Go to Step 37 .
NO -
  • Check the clutch actuator wire harness for an open or short.
  • Substitute a known-good TCM. If the HDS identify the vehicle, replace the original TCM. ■
  1. Disconnect the engine room wire harness 10P connector.
  1. Reconnect the gear shift control module 12P connector.