Crankshaft/Oil Seal (Transmission End) Installation
  1. Connect the CKP sensor connector (A), then install the CKP sensor cover (B).
  1. Install the harness covers (C).
  1. Without i-SHIFT: Install the flywheel, clutch disc, and pressure plate.
  1. With i-SHIFT: Install the flywheel, clutch disc, and pressure plate.
  1. Install the transmission:
    • Without i-SHIFT
    • With i-SHIFT
  1. Install the engine/transmission.
    NOTE: Whenever any crankshaft or connecting rod bearing is replaced, run the engine at idle speed until it reaches normal operating temperature, then continue to running it for about 15 minutes.