Cylinder Head Installation
  1. Connect the fuel feed hose (A), then install the quick-connect fitting cover (B) and the fuel feed hose clamp (C).
  1. Install the warm up three way catalytic converter (WU-TWC).
  1. Install the intake manifold/chamber assembly.
  1. Install the air cleaner housing assembly.
  1. Install the battery. Clean the battery posts and cable terminals with sandpaper, then assemble them, and apply grease to prevent corrosion.
  1. Inspect for fuel leaks. Turn the ignition switch to ON (II) (do not operate the starter) so the fuel pump runs for about 2 seconds and pressurizes the fuel line. Repeat this operation three times, then check for fuel leakage at any point in the fuel line.
  1. Refill the radiator with engine coolant, and bleed air from the cooling system with the heater valve open.
  1. Do the crankshaft position (CKP) pattern clear/CKP pattern learn procedure.
  1. Inspect the idle speed.
  1. Inspect the ignition timing.
  1. Do the power window control unit reset procedure.
  1. Set the clock.