i-SHIFT Gear Shift Control Module Removal/Installation
  1. Install the gear shift control module to the change lever base (A), then connect the connector (B).
    NOTE:
    • Tighten the bolts after making the two locating pins (C) of the gear shift control module and holes (D) at the change lever base are coincide.
    • Installation position is different between LHD model and RHD model.
    • If the gear shift control module was replaced, install the shift lever knob (E) to the gear shift control module (F) (turn the shift lever knob clockwise for 11 to 13 times, and make sure the shift pattern on the knob is at the right place).
  1. Install the front center console.
  1. Install the rear center console.
  1. Test-drive the vehicle.