i-SHIFT System Symptom Troubleshooting - Engine stalls when stopping
Engine Stalls When Stopping
  1. Check the clutch line for leaks and low fluid level.
Is there any problems?
YES -
Repair the problem part, then go to Step 2 .
NO -
Go to Step 3 .
  1. Clear the DTCs with the HDS (invoked due to repair).
  1. Bleed hydraulic system to remove any air bubbles.
  1. Do the i-SHIFT system learning (static mode).
Was the i-SHIFT system learning (static mode) successfully completed?
YES -
Go to Step 6 .
NO -
Go to Step 5 .
  1. Check for DTCs with the HDS.
Are any DTCs indicated?
YES -
Go to the indicated DTC's troubleshooting.■
NO -
Bleed hydraulic system to remove any air bubbles, then do the i-SHIFT system learning (static mode). ■
  1. Test-drive the vehicle for 10 minutes with at least 5 full load start.
    NOTE: During the test-drive, read out the actual clutch temperature with the HDS. Do not start test-drive with clutch temperature above 100 °C (212 °F).
Was the test successfully completed?
YES -
Troubleshooting is complete.■
NO -
Go to Step 7 .
  1. Check for DTCs with the HDS.
Are any DTCs indicated?
YES -
Go to the indicated DTC's troubleshooting.■
NO -
Bleed the hydraulic system to remove any air bubbles, then do the i-SHIFT system learning (static mode). ■