DTC Troubleshooting: P0103 (50)
  1. Connect MAF sensor/IAT sensor 5P connector terminals No. 1 and No. 2 with a jumper wire.
  1. Connect the battery.
  1. Turn the ignition switch ON (II).
  1. Clear the DTC with the HDS.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0103 indicated?
YES -
Go to Step 21 .
NO -
Go to Step 14 .
  1. Turn the ignition switch OFF.
  1. Replace the MAF sensor/IAT sensor.
  1. Reconnect all connectors and the battery.
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Do the ECM idle learn procedure.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0103 indicated?
YES -
Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the ECM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Update the ECM if it does not have the latest software, or substitute a known-good ECM.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0103 indicated?
YES -
Check for poor connections or loose terminals at the MAF sensor/IAT sensor and the ECM. If the ECM was updated, substitute a known-good ECM, then recheck. If the ECM was substituted, go to Step 1 .
NO -
If the ECM was updated, troubleshooting is complete. If the ECM was substituted, replace the original ECM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■