DTC Troubleshooting: P0010 (56)
  1. Check for continuity between VTC oil control solenoid valve 2P connector terminal No. 2 and ECM connector terminal C23.
Is there continuity?
YES -
Go to Step 22 .
NO -
Repair open in the wire between the ECM (C23) and the VTC oil control solenoid valve, then go to Step 15 .
  1. Replace the VTC oil control solenoid valve.
  1. Reconnect all connectors.
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Do the ECM idle learn procedure.
  1. Do the VTC TEST in the INSPECTION MENU with the HDS.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0010 indicated?
YES -
Check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM, then go to Step 1 .
NO -
Go to Step 21 .
  1. Monitor the OBD STATUS for DTC P0010 in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES -
Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in Step 20 , go to the indicated DTC's troubleshooting.■
NO -
If the screen indicates FAILED, check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM, then go to Step 1 . If the screen indicates NOT COMPLETED, go to Step 19 .
  1. Reconnect all connectors.
  1. Update the ECM if it does not have the latest software, or substitute a known-good ECM.
  1. Do the VTC TEST in the INSPECTION MENU with the HDS.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0010 indicated?
YES -
Check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM. If the ECM was updated, substitute a known-good ECM, then go to Step 24 . If the ECM was substituted, go to Step 1 .
NO -
Go to Step 26 .
  1. Monitor the OBD STATUS for DTC P0010 in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES -
If the ECM was updated, troubleshooting is complete. If the ECM was substituted, replace the original ECM. If any other Temporary DTCs or DTCs were indicated in Step 25 , go to the indicated DTC's troubleshooting.■
NO -
If the screen indicates FAILED, check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM. If the ECM was updated, substitute a known-good ECM, then go to Step 24 . If the ECM was substituted, go to Step 1 . If the screen indicates NOT COMPLETED, go to Step 24 .