M/T Countershaft Reassembly

Exploded View
Special Tools Required

Driver, 40 mm I.D.
 07746-0030100

Attachment, 30 mm I.D.
 07746-0030300
NOTE: Refer to the Exploded View, as needed, during this procedure.
  1. Clean all parts in solvent, dry them, and apply MTF to all contact surfaces.
  1. Install the distance collar and needle bearing onto the countershaft.
  1. Install the 1st gear.
  1. Install the triple cone synchro assembly (A) by aligning the synchro ring fingers (B) with the grooves in 1st gear (C), then install the synchro spring (D).