Crankshaft/Oil Seal (Transmission End) Installation
  1. Apply new engine oil to the thrust washer surfaces. Install the thrust washers (A) in the No. 4 journal of the engine block.
  1. Inspect the connecting rod bolts.
  1. Seat the rod journals into connecting rod No. 1 and connecting rod No. 4. Line up the mark (B) on the connecting rod and cap, then install the caps and bolts finger-tight.
  1. Rotate the crankshaft clockwise, and seat the journals into connecting rod No. 2 and connecting rod No. 3. Line up the mark on the connecting rod and cap, then install the caps and bolts finger-tight.
  1. Tighten the connecting rod bolts to 29 N·m (3.0 kgf·m, 22 lbf·ft).