DTC Troubleshooting: U0107 (207)
DTC U0107:
 CAN Malfunction (ISV Actuator Control Module-ECM)
NOTE:
  • Information marked with an asterisk ( * ) applies to the E-CANL line.
  • Before you troubleshoot, record all freeze data and review the general troubleshooting information.
  1. Turn the ignition switch ON (II).
  1. Clear the DTC with the HDS.
  1. Start the engine.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC U0107 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the intake shutter valve and the ECM.■
  1. Check the No. 24 ISV (15 A) fuse in the under-hood fuse/relay box.
Is the fuse OK?
YES -
Go to Step 9 .
NO -
Go to Step 6 .
  1. Turn the ignition switch OFF.
  1. Disconnect the intake shutter valve 10P connector.
  1. Check for continuity between intake shutter valve 10P connector terminal No. 8 and body ground.
Is there continuity?
YES -
Repair short in the wire between the intake shutter valve and the under-hood fuse/relay box, then go to Step 33 .
NO -
Replace the No. 24 ISV (15 A) fuse, then go to Step 33 .
  1. Turn the ignition switch OFF.
  1. Disconnect the intake shutter valve 10P connector.