DTC Troubleshooting: P0403 (182)
  1. Check for continuity between ECM connector No. 1 terminal No. 48 and body ground.
Is there continuity?
YES -
Go to Step 24 .
NO -
Repair open in the wire between the EGR control solenoid valve and ECM connector No. 1 terminal No. 48, then go to Step 19 .
  1. Turn the ignition switch OFF.
  1. Replace the EGR control solenoid valve.
  1. Reconnect all connectors.
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Start the engine, and hold the engine speed at 2,000 rpm (min −1 ) without load.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0403 indicated?
YES -
Check for poor connections or loose terminals at the EGR control solenoid valve and the ECM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Update the ECM if it does not have the latest software, or substitute a known-good ECM.
  1. Start the engine, and hold the engine speed at 2,000 rpm (min −1 ) without load.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0403 indicated?
YES -
Check for poor connections or loose terminals at the EGR control solenoid valve and the ECM. If the ECM was updated, substitute a known-good ECM, then go to Step 26 . If the ECM was substituted, go to Step 1 .
NO -
If the ECM was updated, troubleshooting is complete. If the ECM was substituted, replace the original ECM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■