DTC Troubleshooting: P0103 (50)
  1. Check for continuity between ECM connector No. 1 terminal No. 69 and body ground.
Is there continuity?
YES -
Go to Step 16 .
NO -
Repair open in the wire between the MAF sensor/IAT sensor 1 and ECM connector No. 1 terminal No. 69, then go to Step 12 .
  1. Turn the ignition switch OFF.
  1. Replace the MAF sensor/IAT sensor 1.
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Start the engine.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0103 indicated?
YES -
Check for poor connections or loose terminals at the MAF sensor/IAT sensor 1 and the ECM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Update the ECM if it does not have the latest software, or substitute a known-good ECM.
  1. Start the engine.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0103 indicated?
YES -
Check for poor connections or loose terminals at the MAF sensor/IAT sensor 1 and the ECM. If the ECM was updated, substitute a known-good ECM, then go to Step 18 . If the ECM was substituted, go to Step 1 .
NO -
If the ECM was updated, troubleshooting is complete. If the ECM was substituted, replace the original ECM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■