DTC Troubleshooting: P0097 (10)
DTC P0097:
 IAT Sensor 2 Low Voltage
NOTE: Before you troubleshoot, record all freeze data and review the general troubleshooting information.
  1. Turn the ignition switch ON (II).
  1. Check IAT SENSOR 2 in the DATA LIST with the HDS.
Is about 0.097 V or less indicated?
YES -
Go to Step 3 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the MAP sensor/IAT sensor 2 and the ECM.■
  1. Turn the ignition switch OFF.
  1. Disconnect the MAP sensor/IAT sensor 2 4P connector.
  1. Turn the ignition switch ON (II).
  1. Check IAT SENSOR 2 in the DATA LIST with the HDS.
Is about 0.097 V or less indicated?
YES -
Go to Step 7 .
NO -
Go to Step 10 .
  1. Turn the ignition switch OFF, and wait 2 minutes.
  1. Disconnect ECM connector No. 1 (96P).
  1. Check for continuity between MAP sensor/IAT sensor 2 4P connector terminal No. 3 and body ground.
Is there continuity?
YES -
Repair short in the wire between the MAP sensor/IAT sensor 2 and ECM connector No. 1 terminal No. 17, then go to Step 12 .
NO -
Go to Step 16 .
  1. Turn the ignition switch OFF.
  1. Replace the MAP sensor/IAT sensor 2.
  1. Reconnect all connectors.
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0097 indicated?
YES -
Check for poor connections or loose terminals at the MAP sensor/IAT sensor 2 and the ECM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Update the ECM if it does not have the latest software, or substitute a known-good ECM.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0097 indicated?
YES -
Check for poor connections or loose terminals at the MAP sensor/IAT sensor 2 and the ECM. If the ECM was updated, substitute a known-good ECM, then recheck. If the ECM was substituted, go to Step 1 .
NO -
If the ECM was updated, troubleshooting is complete. If the ECM was substituted, replace the original ECM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■