M/T Differential Carrier Bearing Preload Adjustment
Special Tools Required

Driver
 07749-0010000

Attachment, 78 x 80 mm
 07NAD-PX40100

Preload inspection tool
 07YAJ-S3V0100
If any of the items listed below were replaced, the carrier bearing preload must be adjusted.
  • Transmission housing
  • Clutch housing
  • Differential carrier
  • Spacer
  • Carrier bearing and outer race
  1. Remove the oil seals from the transmission housing and clutch housing.
  1. If you replaced the carrier bearing on the transmission housing side of the carrier, remove and discard the bearing outer race. Heat up the transmission housing to about 100 °C (212 °F) with a heat gun (A), then remove the bearing outer race (B), spacer (C), and 81 mm shim (D). Do not heat the housing in excess of 100 °C (212 °F).