Driveshaft Reassembly
  1. Fit the inboard joint onto the driveshaft, and note these items:
    • Reinstall the inboard joint onto the driveshaft by aligning the marks (A) on the inboard joint and the rollers.
    • Hold the driveshaft so the inboard joint is pointing up to prevent it from falling off.
  1. Adjust the inboard joint until the rollers are in the middle of the joint.
  1. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band onto the boot.
  1. Repeat Step 9 for the band on the other end of the boot, then go to Step 11 .