F-CAN Circuit Troubleshooting
NOTE: Information marked with an asterisk ( * ) applies to the CANL line.
  1. Turn the ignition switch OFF, and wait 2 minutes.
  1. Disconnect ECM connector No. 2 (58P).
  1. Disconnect the HDS from the DLC.
  1. Measure resistance between ECM connector No. 2 terminals No. 47 and No. 48.
Is there about 90−111 Ω?
YES -
Go to Step 35 .
NO -
Go to Step 5 .
  1. Disconnect the gauge control module (tach) 36P connector.
  1. Disconnect the VSA modulator-control unit 46P connector, and the yaw rate/lateral acceleration sensor 4P connector. ■
  1. Disconnect SRS unit connector A (28P).
  1. Disconnect EPS control unit connector D (28P).