M/T Countershaft Reassembly

Exploded View
Special Tools Required

Driver, 40 mm I.D.
 07746-0030100

Attachment, 30 mm I.D.
 07746-0030300
NOTE: Refer to the Exploded View as needed during this procedure.
  1. Clean all parts in solvent, dry them, and apply lubricant to all contact surfaces.
  1. Install the distance collar and the needle bearing onto the countershaft.
  1. Install the 1st gear synchro ring (A), synchro spring (B) and the friction damper (C) on the 1st/2nd synchro hub (D).
  1. Align the fingers (E) on the friction damper with the grooves (F) on the 1st/2nd synchro hub, then install the 1st gear (G) onto the 1st/2nd synchro hub.
  1. Supporting by hand, turn the 1st/2nd synchro hub side upward, then install the 1st/2nd synchro hub with 1st gear on to the counter shaft.