DTC Troubleshooting: P250A (168)
  1. Check for continuity between ECM connector terminal C37 and body ground.
Is there continuity?
YES -
Go to Step 24 .
NO -
Repair open in the wire between the ECM (C37) and the engine oil level sensor, then go to Step 19 .
  1. Turn the ignition switch OFF.
  1. Replace the engine oil level sensor.
  1. Reconnect all connectors and the battery.
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Do the ECM idle learn procedure.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P250A indicated?
YES -
Check for poor connections or loose terminals at the engine oil level sensor and the ECM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Update the ECM if it does not have the latest software, or substitute a known-good ECM.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P250A indicated?
YES -
Check for poor connections or loose terminals at the engine oil level sensor and the ECM. If the ECM was updated, substitute a known-good ECM, then recheck. If the ECM was substituted, go to Step 1 .
NO -
If the ECM was updated, troubleshooting is complete. If the ECM was substituted, replace the original ECM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■