DTC Troubleshooting: P1658 (40)
  1. Measure voltage between ECM connector terminal C1 and body ground.
Is there battery voltage?
YES -
Repair short to power in the wire between the ECM (C1) and the under-hood fuse/relay box, then go to Step 14 .
NO -
Go to Step 20 .
  1. Turn the ignition switch OFF.
  1. Reconnect all connectors and the battery.
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Do the ECM idle learn procedure.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P1658 indicated?
YES -
Check for poor connections or loose terminals at the under-hood fuse/relay box and the ECM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Update the ECM if it does not have the latest software, or substitute a known-good ECM.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P1658 indicated?
YES -
Check for poor connections or loose terminals at the under-hood fuse/relay box and the ECM. If the ECM was updated, substitute a known-good ECM, then recheck. If the ECM was substituted, go to Step 1 .
NO -
If the ECM was updated, troubleshooting is complete. If the ECM was substituted, replace the original ECM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■