Fuel Pressure Relieving
Before disconnecting fuel lines or hoses, relieve pressure from the system by disabling the fuel pump and then disconnecting the fuel tube/quick connect fitting in the engine compartment.
With the HDS
  1. Make sure you have the anti-theft code for the audio system.
  1. Remove the fuel fill cap, to relieve the pressure in the fuel tank.
  1. Turn the ignition switch ON (II).
  1. From the INSPECTION MENU of the HDS, select Fuel Pump OFF, then start the engine, and let it idle until it stalls.
    NOTE:
    • Do not allow the engine to idle above 1,000 rpm (min −1 ) or the ECM will continue to operate the fuel pump.
    • A DTC or a Temporary DTC may be set during this procedure. Check for DTCs, and clear them as needed.
  1. Turn the ignition switch OFF.
  1. Disconnect the negative cable from the battery.
  1. Remove the quick-connect fitting cover (A).
  1. Check the fuel quick-connect fitting for dirt, and clean it if needed.