Engine Oil Pan Installation
  1. Connect the oil level sensor connector (A), then install the oil level sensor cover (B).
  1. Install the two bolts (C) securing the harness holder.
  1. If the engine is still in the vehicle, do the following steps.
  1. Lower the vehicle on the hoist.
  1. Loosen the upper torque rod mounting bolt.
  1. Raise the vehicle on the hoist to full height.
  1. Install the lower torque rod.
  1. Lower the vehicle on the hoist.
  1. Tighten the upper torque rod mounting bolt.
  1. Raise the vehicle on the hoist to full height.
  1. Install exhaust pipe A.
  1. Lower the vehicle on the hoist.
  1. Install the A/C compressor. Install the harness clamp, then connect the A/C compressor clutch connector (with A/C).
  1. Install the A/C condenser fan shroud (with A/C).
  1. Install the drive belt (with A/C).
  1. Refill the engine with engine oil.
  1. Install the engine undercover.