DTC Troubleshooting: B1077
DTC B1077:
 Windshield Wiper (As) Signal Error
  1. Clear the DTCs with the HDS.
  1. Turn the ignition switch OFF, and then back ON (II).
  1. Turn the wiper switch to LOW or HIGH for at least 15 seconds, then turn the switch OFF.
Do the wiper arms stop at AUTO STOP position?
YES -
Go to Step 4 .
NO -
Go to Step 12 .
  1. Check for DTCs with the HDS.
Is DTC B1077 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the windshield wiper system is OK at this time. Check for loose or poor connections.■
  1. Turn the ignition switch OFF.
  1. Do the windshield wiper motor test.
Does the windshield wiper motor run normally?
YES -
Go to Step 7 .
NO -
Replace the windshield wiper motor and recheck.■
  1. Disconnect the under-dash fuse/relay box connector F (34P) and windshield wiper motor 5P connector.
  1. Check for continuity between the No. 4 terminal of the windshield wiper motor 5P connector and No. 32 terminal of the under-dash fuse/relay box connector F (34P).
Is there continuity?
YES -
Go to Step 9 .
NO -
Repair an open in the WHT wire.■

LHD:
RHD: