Power Window Passenger's Switch Input Test
NOTE: The power window control unit is built into the passenger's window switch.
  1. Remove the passenger's window switch (A).
  1. Disconnect the 14P connector (B) from the passenger's window switch.
  1. Inspect the connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals look OK, go to Step 4 .
  1. With the connector still disconnected, make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, go to Step 5 .
    Cavity
    Wire
    Test condition
    Test: Desired result
    Possible cause if result is not obtained
    1
    BLK
    Under all conditions
    Check for continuity to ground: There should be continuity.
    • Poor ground (G502)
    • An open in the wire
    2
    BLK
    7
    GRN
    Ignition switch ON (II)
    Check for voltage to ground: There should be battery voltage.
    • Blown No. 6 (P/W) (40 A) fuse in the under-hood fuse/relay box
    • Blown No. 30 (20 A) fuse in the under-dash fuse/relay box
    • Faulty power window relay
    • Faulty under-dash fuse/relay box
    • An open in the wire
    3
    PUR
    Under all conditions
    Check for continuity between the No. 3 terminal and the power window master switch 22P connector No. 2 terminal: There should be continuity.
    An open in the wire
    14
    RED
    Connect the No. 7 and the No. 14 terminals and No. 8 and No. 1 terminals momentarily with jumper wires
    Check passenger's power window motor operation: The window should go down.
    • Faulty passenger's power window motor
    • An open in the wire
    8
    BLU
    Connect the No. 7 and the No. 8 terminals and No. 14 and No. 1 terminals momentarily with jumper wires
    Check passenger's power window motor operation: The window should go up.
    • Faulty passenger's power window motor
    • An open in the wire

  1. Reconnect the 14P connector to the passenger's window switch. Turn the ignition switch ON (II), and make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, the control unit must be faulty; replace the passenger's power window switch.
    Cavity
    Wire
    Test condition
    Test: Desired result
    Possible cause if result is not obtained
    6
    PUR
    Ignition switch ON (II)
    Check for voltage to ground: There should be battery voltage.
    A short to ground in the wire
    5
    PNK
    Ignition switch ON (II), and passenger's power window switch moving up or down
    Check for voltage between the No. 5 and No. 6 terminals: There should be 0 V−about 5 V−0 V− about 5 V repeatedly (a digital voltmeter should reads about 2.5 V while the window moves).
    • Faulty passenger's power window motor
    • An open in the wire
    • A short to ground in the wire
    4
    ORN
    Ignition switch ON (II), and passenger's power window switch moving up or down
    Check for voltage between the No. 4 and No. 6 terminals: There should be 0 V−about 5 V−0 V− about 5 V repeatedly (a digital voltmeter should reads about 2.5 V while the window moves).

  1. Reset the power window control unit.