Quarter Glass Replacement
  1. Attach the front seal (A) with adhesive tape A and rubber dam (B) with adhesive tape B to the inside face of the quarter glass (C) as shown. Before installing the front seal and rubber dam, apply primer to the glass, then attach the front seal and rubber dam.
    • Be careful not to touch the quarter glass where adhesive will be applied.
    • Be sure the bottom of front seal contacts the upper clip (D).
    • Be sure the rubber dam line up with rear end of the quarter glass.
    Adhesive tape A:
    Thickness 0.8 mm (0.03 in.)
    Width 6 mm (0.24 in.)
    Adhesive tape B:
    Thickness 0.2 mm (0.008 in.)
    Width 3 mm (0.12 in.)