Pack adhesive into the cartridge without air pockets to ensure continuous delivery. Put the cartridge in a caulking gun, and run a bead of adhesive (A) on the rear window (B) around the edge of the upper rubber dam (C), corner moldings (D), side moldings (E), and lower rubber dam (F) as shown.

Apply the adhesive within 30 minutes after applying the glass primer. Make a slightly thicker bead at each corner.

Use suction cups to hold the windshield over the opening, align the clip, and set it down on the adhesive. Lightly push on the extra window until its clips snap into place securely and its edges are fully seated on the adhesive all the way around.

NOTE: Do not open or close any of the doors for about an hour until the adhesive is dry.