Under-dash Fuse/Relay Box Removal and Installation
SRS components are located in this area. Review the SRS component locations and precautions and procedures before performing repairs or servicing.
Removal
  1. Make sure you have the anti-theft code for the audio or the navigation system (if equipped), then write down the audio presets.
  1. Make sure the ignition switch is OFF.
  1. Disconnect the negative battery cable, then disconnect the positive cable, and wait at least 3 minutes.
  1. Remove the left (or right) front door still trim and left (or right) kick panel.
  1. Disconnect the connectors from the fuse side of the under-dash fuse/relay box (A).
  1. Remove the mounting bolt, and pull the fuse/relay box away from the body.
  1. Disconnect the connectors from the back side of the under-dash fuse/relay box, then remove the under-dash fuse/relay box.
  1. Carefully remove the relays by prying under the base of the relay.
    NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start.