Audio Unit Removal/Installation
SRS components are located in this area. Review the SRS component location. Also review the precautions and procedures in the SRS section before doing repairs or service.
NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the dashboard and related parts.
  • Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.
  • Do not work in a dusty or dirty place.
  • Discharge static electricity from your body before and during the work.
  • Do not work with dirty hands.
  1. Write down the radio station presets.
  1. Remove the dashboard center upper lid, rear center console, and front center console.
  1. Remove the bolts and screws, then pull out the center panel (A).
  1. Disconnect the connectors (B), then remove the wire harness clip (C) and the center panel.
  1. Install the audio unit in the reverse order of removal, and note these items:
    • Make sure all connectors and antenna lead are secure.
    • Enter the customer's radio station presets, and set the clock.