Steering Wheel Installation
  1. Install the steering wheel bolt (A), and tighten it to the specified torque. Connect the cable reel subharness connector (B). Make sure the wire harness is routed and fastened properly.
  1. Install the driver's airbag, and confirm that the system is operating properly.
  1. Reconnect the negative cable to the battery and do the following items:
    • Turn the ignition switch ON (II), the SRS indicator should come on for about 6 seconds and then go off.
    • Set the clock.
    • Verify cruise control, audio remote, navigation guide (if equipped) and turn signal canseling for proper operation.
    • Make sure the steering wheel is centered.