Steering Column Removal and Installation
  1. Disconnect the wire harness connectors from the combination switch assembly and cable reel (A).
  1. Remove the combination switch assembly from the steering column shaft by removing the three screws (B).
  1. Disconnect the connectors from the ignition switch, and release the wire harness clips from the steering column.
  1. Remove the steering joint bolt (C), then disconnect the steering joint (D) from the pinion shaft.
  1. Remove the steering column (E) by removing the attaching nuts and bolts. If the lower slide shaft (F) is removed, slip it into the upper shaft (G) by aligning the paint or stamped marks (H).
  1. Remove the center guide (I) (if equipped), and discard it. The center guide is for factory assembly only.