Rear Spring Replacement
  1. Lower the rear axle beam. Align the spring lower end (A) with the stepped part (B), and install the spring lower seat (C) to the rear axle beam (D) as shown.
  1. Place a floor jack under of the rear axle beam, and support the rear suspension by raising the jack.
  1. Install the new flange bolts to the bottom of dampers on the right and left side.
  1. Install the brake line with the new clips on the right and left side.
    NOTE:
    • After installing, fill the reservoir with new brake fluid, and bleed the brake system.
    • Check the brake hose and line joint for leaks, and tighten if necessary.
    • Check the brake hoses for interference and twisting.
  1. Install the wheel sensor harness clips on the left and right side.
  1. Install the rear spring seat lower cover.
  1. For with HID lamp model: Install the headlight rear leveling sensor.
  1. Install the rear wheels.
    NOTE: Before installing the wheel, clean the mating surface of the hub bearing unit and the inside of the wheel.
  1. Check the rear wheel alignment.
  1. For with HID lamp model: Do the headlight learning procedure.