( SMR9EQDK79600090914FAAT00 )

DTC Troubleshooting: P0914 (162-5)

DTC P0914:

Shift Actuator Motor Rotating Pulse Sensor Signal Circuit Malfunction

Turn the ignition switch to ON (II).

Clear the DTCs with the HDS.

Change the shift lever to D, then operate the shift lever between + and − positions.

Check for DTCs with the HDS.

Is DTC P0914 indicated?

YES	-	Go to Step 5 .
NO	-	Intermittent failure, the system is OK at this time.■

Turn the ignition switch to LOCK (0).

Disconnect the shift actuator motor 6P connector.

Turn the ignition switch to ON (II).

Check for DTCs with the HDS.

Is DTC P0914 indicated?

YES	-	Go to Step 9 .
NO	-	Replace the transmission shift change actuator; R18A2 engine model, L13Z1 engine model. (A few DTCs related with open circuit will be stored at this time.)■

Turn the ignition switch to LOCK (0).

Disconnect change actuator subharness B 8P connector (R18A2 engine model) or TCM connector B (40P) (L13Z1 engine model).

Check for continuity between the shift actuator motor 6P connector terminal No. 5 and body ground.

Is there continuity?

YES	-	Repair a short to ground in the wire of the change actuator subharness B (R18A2 engine model) or change actuator subharness A (L13Z1 engine model).■
NO	-	Go to Step 12 .

Turn the ignition switch to ON (II).

Measure the voltage between shift actuator motor 6P connector terminal No. 5 and body ground.

Is there battery voltage?

YES	-	Repair a short to power in the wire of the change actuator subharness B (R18A2 engine model) or change actuator subharness A (L13Z1 engine model).■
NO	-	Go to Step 14 .

Turn the ignition switch to LOCK (0).

Check for continuity between shift actuator motor 6P connector terminal No. 5 and change actuator subharness B 8P connector terminal No. 2 (R18A2 engine model) or TCM connector B9 (L13Z1 engine model).

Is there continuity?

YES	-	R18A2 engine model: remove the clutch actuator assembly, and check for change actuator subharness A. If the wire harness is OK, update the TCM if it does not have the latest software or substitute a known-good TCM, then recheck. If the symptom/indication goes away with a known-good TCM, replace the original TCM. L13Z1 engine model: update the TCM if it does not have the latest software or substitute a known-good TCM, then recheck. If the symptom/indication goes away with a known-good TCM, replace the original TCM. ■
NO	-	Repair an open in the wire of the change actuator subharness B (R18A2 engine model) or change actuator subharness A (L13Z1 engine model).■