i-SHIFT Clutch Fluid Tube Assembly Replacement
NOTE:
  • Use fender covers to avoid damaging painted surfaces.
  • Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
  1. Raise the vehicle, and make sure it is securely supported.
  1. Disconnect the clutch fluid tube (A) from the clutch actuator (B). Plug the end of the clutch fluid with a shop towel to prevent brake fluid from coming out. Remove the clutch fluid tube from the clip (C).
  1. Lower the vehicle, and make sure it is securely supported.
  1. Remove the clutch reservoir tank (A) from the bulkhead (B), then remove the reservoir tube (C) from the clip (D). Replace to the new clutch fluid tube assembly.
    Wher remove the reservoir tank, fix the reservoir tank by hand.
  1. Install the clutch reservoir tank (A) on the bulkhead (B), then install the reservoir tube (C), from the clips (D).
    NOTE: Make a mark (E) on this side and insert the tube into the clip.
  1. Raise the vehicle, and make sure it is securely supported.
  1. Connect the clutch fluid tube (A) on to the clutch actuator (B), then install the clutch fluid tube to the clip (C).
    NOTE:
    • Match the mark of tube (D) with the mark of grommet (E).
    • Install the tube till the mark is matched to the protrusion of tube.
    • Application of oil is not allowed.
    • Make a mark (F) on this side and insert the tube into the clip.
  1. Check the clutch operation and check for leaking fluid.
  1. Test-drive the vehicle.