M/T Assembly Installation
Special Tools Required

Engine support hanger
 AAR-T1256-J00
*
*: This special tool is available from Snap-on Tools    International, LLC.
NOTE: Use fender covers to avoid damaging painted surfaces.
  1. Make sure two dowel pins (A) are installed in prescribed hole on the engine block as shown.
  1. Place the transmission on the transmission jack, and raise it to the engine unit level.
  1. Install the lower transmission mounting bolts.
Front side
Rear side
  1. Install the lower torque rod bracket (A) with new bolts.
  1. Install the lower torque rod (A) with new bolts.
  1. Install the clutch cover (A).
  1. Install the converter bracket (A).
  1. Install the driveshaft heat shield (A).
  1. Lower the vehicle on a lift.
  1. Install the transmission mounting bracket base (A). Install the new transmission mounting bolt (B) and stud bolts (C).
  1. Install the new transmission mounting bracket bolts (A) and new nuts (B), then install the ground cable (C).
  1. Raise the vehicle on a lift.
  1. Loosen and retighten the lower torque rod mounting bolt.
  1. Lower the vehicle on a lift.
  1. Loosen the wing nut (A). Remove the hook (B) and engine support hanger (C) from the vehicle.
  1. Remove the hanger plate (A) to the air cleaner housing mounting bracket (B) with the 8 x 1.25 mm bolt (C). Install the purge control SOL.V. hose (D).
  1. Install the one upper transmission mounting bolt.
  1. Connect the output shaft (countershaft) speed sensor connector (A), then install the harness bracket (B).
  1. Install the air cleaner housing bracket (A) with the air cleaner housing stay (B).
  1. Connect the back-up light switch connector (A), then install the harness clips (B).
  1. Install the battery. Connect the positive cable first, then the negative cable to the battery.
  1. Check the clutch operation.
  1. Test-drive the vehicle.
  1. Enter the anti-theft code for the audio or the navigation system, then enter the customer's audio presets, and set the clock.